![]() ![]() Motorola MotoTRBO Programming Software (GMVN5141) This CPS 1.0 v16 Build 828, supports up to MOTOTRBO system release R2.9 (including minor releases) while the new CPS2.0 supports MOTOTRBO system releases R2.4 onward (including minor releases). Motorola CPS v16 Programming Software Download. Motorola MOTOTRBO CPS 16.0 Build 828 USA Programming Software. > DOWNLOAD: Motorola Mototrbo Cps Software Download If you've done all of the above and are (now) getting another error message, have a look at a post from a while back, on this topic.Motorola Mototrbo Cps Software Download JMotorola Mototrbo Cps Software Download If the radio shows up in Windows Device Manager as a FlashZap device then you've "bricked" your radio and it needs to be returned for repair. Have a look at the radio display and check whether the radio works normally otherwise. Try another radio on the same setup: if that radio works then you've narrowed it down to this radio. If you've checked the above, you might have a defective radio. By default the IP address of the radio is 192.168.10.1. Since the radio is seen as a network connection by Windows, you can ping it. USB 3.0 ports will have blue insulator material - USB 2.0 ports are black.Ĭan you ping the radio. These are known to be quirky so try a USB 2.0 port to eliminate this as a cause. If the radio appears in the Unknown Devices tree in Windows Device Manager, then you need to make sure the CPS is installed on this PC or, at the very least, the driver files.Īre you using a USB 3.0 port. In Windows Device Manager the radio will show up as a network adapter.ĭid the driver load. In Network Connections the radio will show up as a network connection with an IP address. Once the RNDIS driver is loaded, have a look in your Network Connections and in Windows Device Manager. Wait a few seconds before pressing the read button.Ĭan you see the radio in Windows. ![]() The RNDIS driver takes a few seconds to load depending on how fast/cluttered your PC is. Here is a video showing the sounds that Windows 7 will produce. When the radio is plugged in to the PC, a USB RNDIS driver gets loaded. Windows will notify you when the radio is connected and disconnected. Even I get caught out by this more often than I care to admit.ĭoes Windows "see" the radio. You will either need to get a PMKN4012B or modify (caveat emptor) your cable to support this (details can be found on the internet). On that point, if you have a PMKN4012A and a DP4000 series radio, this combination wont work. So if you plug in the cable, Windows will not see it as a device. The thick round thing on the cable is just a RF choke. There is no intelligence in the programming cable. An old toothbrush with a little contact cleaner or methanol will make sure those contact are clean. Sometimes dirt and other interesting things can get onto the accessory connector terminals - especially portables. Is the programming cable really plugged into the PC and connected to the radio. There are a number of causes for this and many of them can be solved with a few simple checks.Ĭheck the connections. It basically means that the radio did not respond. If you've ever read a MOTOTRBO radio, you might have come across this error message. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |